FREE UK MAINLAND DELIVERY ON ORDERS OVER £50
Not Find Exactly What You Need?
Advance Search
Not Find Exactly What You Need?
Advance Search
Mounting and dismounting are simple and the axial location effective and reliable. Neither additional locking washers nor keyway in the shaft are required. The KMFE nuts can be re-used.
The KMFE nuts have slots in the outside diameter so that they can be tightened using a hook or impact spanner. A hexagonal wrench is needed to tighten the grub screw. Appropriate sizes of the spanner are provided in the product table. Tighten the grub screw, until the recommended tightening torque quoted in the product table is obtained.
Dimensions The dimensions and the thread of KMFE nuts are in accordance with ISO 2982-2:1995, except for the width. The grub screw correspond to ISO 4026:1993, material class 45H.
Tolerances The metric ISO thread is machined to tolerance 5H according to ISO 965-3:1998.
The maximum runout between the thread and the locating face is 0,04 mm.
Material SKF lock nuts in the KMFE series are made of steel and are protected by a solventless rust inhibitor.
Mating shaft threads
SKF recommends that the mating thread on the shaft be made to 6g according to ISO 965-3:1998.
Bearing accessories | Adapter sleeves | Withdrawal sleeves | Lock nuts | Lock nuts with locking washer or clip | Lock nuts with locking screw | Lock nuts with integral locking device | Precision lock nuts with locking pins | Hydraulic nuts
All trademarks, logos and brand names used on this website are the property of their respective owners. All company, product and service names used in this website are for identification purposes only. Use of these names, trademarks and brands does not imply endorsement.
bearingswebshop.com is a trading name of 1T Solutions Limited bearingswebshop.com
© 2008 – 2025 1T Solutions Limited. All Rights Reserved.
Disclaimer:
Errors and Omissions Excepted.
Any dimensions, tolerances or performance figures shown on this website and any associated documents are for guidance only. For factual figures, reference should be made to the current edition of the appropriate standards where applicable.
Every effort is made to keep the information on this website accurate and up to date. However, bearingswebshop.com accepts no responsibility for errors or omissions or for any third party loss or consequences arising from what is published.
The information within this website is based on our present knowledge and experience, and is supplied in good faith.
No liability is accepted by bearingswebshop.com. in respect of any action taken by a third party.
The products detailed on this website may be used for a variety of purposes and as bearingswebshop.com has no control over their use. bearingswebshop.com excludes all conditions and warranties expressed or implied by statue or otherwise, as to dimensions, properties and/or their suitability for an application.
