FREE UK MAINLAND DELIVERY ON ORDERS OVER £50
Not Find Exactly What You Need?
Advance Search
Not Find Exactly What You Need?
Advance Search
These lock nuts of the KMK design (fig 1) have an integral locking device, which takes the form of a pressure plate, the surface of which has a threaded profile. The pressure plate is pressed against the shaft thread by a grub screw, thus locking the nut in position (fig 2).
Mounting and dismounting are simple and the axial location effective and reliable. Neither additional locking washer nor keyway in the shaft is required. The KMK nuts can be re-used.
The KMK nuts have slots in the outside diameter so that they can be tightened using a hook spanner. A hexagonal wrench is needed to tighten the grub screw. Appropriate sizes of spanner and key are provided in the product table. Tighten the grub screw, until the recommended tightening torque quoted in the product table is obtained.
Dimensions
The dimensions and the thread of the KMK nuts are in accordance with ISO 2982-2:2001, except for the width. The grub screw corresponds to ISO 4026:1993, material class 45H.
Tolerances
The metric ISO thread is machined to tolerance 5H according to ISO 965-3:1998.
The maximum runout between the thread and the locating face is 0,02 mm.
Material
SKF lock nuts in the KMK series are made of steel and are phosphated and protected by a solventless rust inhibitor.
Mating shaft threads
SKF recommends that the mating thread on the shaft to be made to 6g according to ISO 965-3:1998.
Bearing accessories | Adapter sleeves | Withdrawal sleeves | Lock nuts | Lock nuts with locking washer or clip | Lock nuts with locking screw | Lock nuts with integral locking device | Precision lock nuts with locking pins | Hydraulic nuts
All trademarks, logos and brand names used on this website are the property of their respective owners. All company, product and service names used in this website are for identification purposes only. Use of these names, trademarks and brands does not imply endorsement.
bearingswebshop.com is a trading name of 1T Solutions Limited bearingswebshop.com
© 2008 – 2025 1T Solutions Limited. All Rights Reserved.
Disclaimer:
Errors and Omissions Excepted.
Any dimensions, tolerances or performance figures shown on this website and any associated documents are for guidance only. For factual figures, reference should be made to the current edition of the appropriate standards where applicable.
Every effort is made to keep the information on this website accurate and up to date. However, bearingswebshop.com accepts no responsibility for errors or omissions or for any third party loss or consequences arising from what is published.
The information within this website is based on our present knowledge and experience, and is supplied in good faith.
No liability is accepted by bearingswebshop.com. in respect of any action taken by a third party.
The products detailed on this website may be used for a variety of purposes and as bearingswebshop.com has no control over their use. bearingswebshop.com excludes all conditions and warranties expressed or implied by statue or otherwise, as to dimensions, properties and/or their suitability for an application.
