FREE UK MAINLAND DELIVERY ON ORDERS OVER £50
Not Find Exactly What You Need?
Advance Search
Not Find Exactly What You Need?
Advance Search
Y-bearings in the 17262(00)-2RS1 and 17263(00)-2RS1 series, with a standard inner ring, have Normal tolerances for the bearing bore diameter and are located on the shaft using an appropriate interference fit. The only difference between these Y-bearings and deep groove ball bearings in the 62 or 63 series is the sphered outside surface of the outer ring.
Y-bearing with standard inner ring
These Y-bearings are suitable for applications where smooth running is a key operating requirement. These bearings can accommodate heavier axial loads than Y-bearings of any other design.
The SKF range comprises bearings for metric shafts from 17 to 60 mm.
Terminology | Y-bearings with grub screw locking | Y-bearings with an eccentric locking collar | Y-bearings with a tapered bore | Y-bearings with a standard inner ring | Y-bearings with a hexagonal or square bore | Special design bearings | Seals | Dimensions | Tolerances | Radial internal clearance | Cages | Grease fill | Speeds | Shaft tolerances | Rubber seat rings | Axial load carrying ability | Equivalent bearing load | Mounting and dismounting | Designations
All trademarks, logos and brand names used on this website are the property of their respective owners. All company, product and service names used in this website are for identification purposes only. Use of these names, trademarks and brands does not imply endorsement.
bearingswebshop.com is a trading name of 1T Solutions Limited bearingswebshop.com
© 2008 – 2025 1T Solutions Limited. All Rights Reserved.
Disclaimer:
Errors and Omissions Excepted.
Any dimensions, tolerances or performance figures shown on this website and any associated documents are for guidance only. For factual figures, reference should be made to the current edition of the appropriate standards where applicable.
Every effort is made to keep the information on this website accurate and up to date. However, bearingswebshop.com accepts no responsibility for errors or omissions or for any third party loss or consequences arising from what is published.
The information within this website is based on our present knowledge and experience, and is supplied in good faith.
No liability is accepted by bearingswebshop.com. in respect of any action taken by a third party.
The products detailed on this website may be used for a variety of purposes and as bearingswebshop.com has no control over their use. bearingswebshop.com excludes all conditions and warranties expressed or implied by statue or otherwise, as to dimensions, properties and/or their suitability for an application.
